Procurve Network OOBM

Network OOBM

Connect the Network patch cable you want to use for remote management (out of band) to the port marked “Management Port” (out of band).

Start up a terminal emulator program on a laptop and connect a console cable to the port marked Console (see above)

Set up OOBM

Basic Configuration

HP Switch# config                               Move to configuration context

HP Switch(config)# oobm                         Move into the OOBM context,

HP Switch(config)# enable

HP Switch(oobm)# interface enable               Enable the interface.

HP Switch(oobm)# ip address 10.1.1.10/21        Add IP address and default gateway to

HP Switch(oobm)# ip default-gateway 10.1.1.1    the interface.

HP Switch(oobm)# end                            Exit back to configuration context.

HP Switch# ping source oobm <router ip>         Verify connectivity w/an uplink device.